Product Overview
Wavetable Drone Synthesizer
OVERVIEW
DRONES is a WAVE TABLE SYNTHERSIZER for sustained sounds.
It can be used to create various sound effects and even drone sounds.
It is equipped with a 4-pole filter, which can be modulated by the built-in LFO.
The LFO has 4 different modes.
Sine, Sawtooth, Square, Sample & Hold, and Random,
These can be controlled with a single knob.
CONTROL
WAVETABLE.
Contains over 200 waveforms, which can be smoothly varied.
Also included at the end of the knobs are sawtooth waveforms, sine waveforms, and a noise generator that varies with frequency, in that order.
PITCH
Sets the reference pitch of the oscillator.
CUTOFF / RES
The DRONES is equipped with a 4-pole low-pass filter with resonance.
Turning the CUTOFF knob to the left causes the notes to decay in order from the highest to the lowest, and no sound is produced when the knob is fully turned.
Turning the RES knob to the right causes a peak at the pitch of the cutoff point.
LFO
DRONES has a built-in LFO that can output sine, sawtooth, square, or sample-and-hold random waveforms. the LFO knob sets two things: the LFO frequency and the waveform.
Turning the knob clockwise speeds up the frequency and switches to the next waveform when the highest frequency is reached.
AMOUNT
LFO can be adapted to WAVETABLE, PICTH, or CUTOFF.
Turning the knob to the right increases the amount of adaptation and switches to the next target when the highest point is reached.
CV
CV input is adapted to PITCH
SIGNAL PATH
